How to Prioritize Your Network Traffic with DD-WRT. Code Composer Studio V5 License Cracking more. Using a computer’s MAC address is a great way to prioritize its traffic because it. Please Name Windows. We have seen Windows machines with more than 300 IPv6 addresses — which, recall, means that every 150 seconds they will be transmitting 30 multicast packets per second which have to be flooded through the network. That problem was caused by a broken Intel NIC driver — Windows attempts to. LanTraffic V2 is a traffic generator software for Windows platforms from. LanTraffic V2 uses the Microsoft Windows TCP/IP. Multicast IP traffic (IPv4. A method to test multicast routing from various points in the network to confirm and troubleshoot where and how multicast traffic.

Hello All, I have been training on Multicast for a while now and whenever I start the topic, I find out that my friends / Colleagues mention that they do not know how to test Multicast Joins. As most of the multicast would be video traffic and they should technically have a whole slew of setup to send and receive some video traffic. Simple way to do it in a Cisco router is as follows. This applies for all the multicast modes 1. Sparse Mode 2.

Dense Mode 3. Sparse-Dense Mode The below is the topology that I will be using, Please note for the article sake to be more productive, I have chosen emulation with GNS3 itself. R1--fa0/0-----r5-fa0/1---- r4 R1 will be the multicast server, R4 will be the multicast receiver. What has been assumed in this simulation is: 1.

There is an IGP, in this case EIGRP running between r1,r5 and r5 2. There is Pim dense mode (any mode of your choice) running and devices are pim adj Now, on the server end, in order to generate traffic, a simple Ping can be used as follows: r1#ping 224.6.7.8 repeat 100 Type escape sequence to abort.

Sending 100, 100-byte ICMP Echos to 224.6.7.8, timeout is 2 seconds. Select all You you will see, the pings are failing, because there isn't a host who wants to receive this traffic.